OP60
The OP60 Oil Pressure Gauge displays engine oil pressure in Psi or Bars. It has built-in calibration curves for most popular
pressure senders manufactured by VDO, Teleflex, Faria, Stewart-Warner, GM and others (sender not provided). The sender type is easily selected
with the front panel keys. Low and High pressure alarms can be set over the entire range of the instrument/sender. When activated, the OP60 built-in
85 dB alarm will sound and the display will flash. The alarms can be enabled or disabled with a single key press. Five levels of backlighting can be
selected and all set-up, calibrations constants, alarm values, and sender type is saved to non-volatile memory. Data is output on an NMEA 0183
compatible serial data output.
All constants and calibrations are pre-set during manufacture but you may alter these settings to suit your particular needs. Calibrations can
be altered over a wide range using the front-panel switches. All information is automatically saved to non-volatile memory.
With a press of the button you can display oil pressure (in PSI or Bars), High and Low oil pressure alarm set-points.
The OP60 draws only 0.017 amps and 5 levels of backlight (including OFF) can be selected from the front panel.
The OP60 outputs oil pressure on the standard NMEA 0183 serial data line at 4800 BAUD.
This ASCII information can be used to log performance or repeat the display information at a remote location
on the CruzPro RP60, RP110 and MaxRp110 data repeaters (see www.cruzpro.com/rp60.html,
www.cruzpro.com/rp110.html and www.cruzpro.com/maxrp110.html). If NMEA 0183 serial data
is not required, then the output terminal can be programmed as an external alarm output pin.
